Search results

Since Russ isn't on Facebook post up some newer pics here.

just need enough room for the link arm bolt to clear the frame rail when the bar swings past it.

A fully sealed battery is required so AGM is pretty much the choice.

I'd say if you're rebuilding your engine more than once a season then you need to find another motor builder or you beat your **** too hard. lol - - - Updated - - - I know many guys go over a season if possible.

yup call Russ Gearhart @ 1 269 278 6945

I've heard a lot of good about the MUDD RII. I'd try them, seem to be much better service than birch by far. and the MUDD RII works just as good as any other. Talk to John Mudd of Motorsport Communications at 866-966-8672

ps250 is 3.62 to 1

The scs Cheeta shifters are pretty sweet and very durable.

www.Midweststeering.com 17 ci valve, nonload sensing, open center. You should only use a lock valve on the rear steer. I'm guessing you mean the cross over relief. So far Vince is the only one I can find with the double cross over relief that bolts to the orbital. other wise...

Anytime you weld to cast you should preheat it and you should use a nickel type rod if it's stick Though I have used 7018 and had good luck. If it's mig you definitely need to preheat and use a specific wire. I can't remember it's designation at the moment. also it helps to make all the tabs...

It's going to have a Ram Charger body on it.

What you have in the pic is what is under Larry Quicks Ghost Rider. He rarely breaks anything. in that aspect

Those are PS250 Rockwell with a nonflanged housing 3.62 to 1 at the planet diffs are probly 5.29 ratio.

lol oh it was

What does water hurt? The sun baked ones are the ones you don't want. a little green algae blows right off with a pressure washer.

Havin some fun at TGW in King Knob WV. The cracked lower kingpin weld didn't like the air. lol https://www.youtube.com/watch?v=6PiFfzsfgZ4&hd=1

:cough: :cough: Blackburne :cough: :cough: lol I'm not proud.

I was told they were just tired of all the bull. Everyone on the outside thinks it's all peaches to have a monster truck operation. but really it's a tough love way of life. There are only a few that have it made.

Saw this forsale if anyone is lookin http://www.tgwforums.com/post/concussion-monster-truck-chassis-6828956?pid=1282157472#post1282157472

I have a local battery guy really tryin to push them. I havn't tried them but I think the next one I buy will be one of these